MUTOH XPJ-461UF - Page 81

Set2: Advanced 81
• 6-color configuration
Nozzle Settings
Steps
1. Print the select nozzle patterns and find the pattern that does not have missing lines.
2. Go to "Nozzle Settings" and choose the pattern selected in the Step 1.
• Select “ALL”, or one of “A” to “D”.
Type US11 UH21
Light
Perform automatic white ink maintenance less
frequently.
If you are printing with the white ink, perform
cleaning as needed.

Normal Default setting. 
Full
Use this mode when color inconsistencies
appear on the print.
 N/A
Advanced Settings 11: Select Nozzle
If missing lines still persist after several attempts of cleaning, you can check the
nozzle conditions by printing the select nozzle patterns and choose only good
nozzles for printing.
• This feature is disabled for single-layer printing.
• This feature is enabled only when the effect setting is set to "i-Weave UV" or
"None".
Setting values
"Confirm pattern" P. 82
"Nozzle Settings" P. 82
Goes to the nozzle settings menu.
Submenus
Nozzle All / Nozzle A to Nozzle D
AdvancedSetting11
SelectNozzle
SelectNozzle1
 Print
SelectNozzle2
NozzleSettings
SelectNozzle2
NozzleSettings
NozzleSettings：
   NozzleALL