NCR 7197 II SERIES - Page 56

7197 Series II Service Manual Chapter 3: Diagnostics
June 2011
36
For Ethernet Model
Select a sub-menu:
- EXIT -> 1 Click
- Print Current Configuration -> 2 Clicks
- Set Communication Interface -> 3 Clicks
- Set Diagnostics Modes -> 4 Clicks
- Set Emulation/Software -> 5 Clicks
- Set Hardware Options -> 6 Clicks
- Set Default Code page -> 7 Clicks
- Set EEPROM To Default -> 8 Clicks
- Set Ethernet-info To Default -> 9 Clicks
Enter code, then hold Button DOWN
at least 1 second to validate