7197 Series II Service Manual Chapter 3: Diagnostics
June 2011
44
Carriage Return Usage
This function allows the printer to ignore or use the Carriage Return (hexadecimal 0D)
command depending on the application. Some applicatons expect the command to be
ignored while others use the command as a print command. (See “Configuring the
Printer” for instructions on how to enter the Configuration Menu to change this setting.)
Press the Paper Feed Button for the carriage return usage you want.
** SET CARRIAGE RETURN USAGE ?
YES -> Long Click
NO -> Short Click
Ignore CR -> Long Click
Use CR as Print Cmd* -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
Asian Mode
This function makes it possible for the user to select an Asian character for the printer. (See
“Configuring the Printer” for instructions on how to enter the Configuration Menu to
change this setting.)
Note: For Asian code pages, only one (either 932, 936, 949 or 950) will exist in the
firmware.
Press the Paper Feed Button for the asian mode you want.
** SET ASIAN MODE ?
YES -> Long Click
NO -> Short Click
Asian Mode On -> Long Click
Asian Mode Off* -> Short Click
Note: Press the Paper Feed Button for at least one second to validate the selection.
Receipt Synchronization
This function makes it possible for the user to select whether to enable or disable receipt
synchronization printing. (See “Configuring the Printer” for instructions on how to enter
the Configuration Menu to change this setting.)
When "Receipt synchronization" is enabled (mode1 or mode2), printer returns the status
for buffered status command after confirming the start of printing.
The following commands are the buffered status command.
1B 75 0 Transmit Peripheral Device Status
1B 76 Transmit Printer Status
1D 49 n Transmit Printer ID
1D 72 Transmit Status
To Next Page
Loading...
Need help?
General
