10-12 Chapter 10: Serial Programming Commands
Selection
Setting
* Indicates default
Serial
Command
# Indicates a
numeric entry
Chapter
Add Prefix PREBK2## 4
Clear One Prefix PRECL2 4
Prefix
Clear All Prefixes PRECA2 4
Add Suffix SUFBK2## 4
Clear One Suffix SUFCL2 4
Suffix
Clear All Suffixes SUFCA2 4
*Enable RMVFNC0 4
Function Code Transmit
FNC1 4
Disable RMV
Intercharacter Delay DLYCHR## 4
Delay Length DLYCRX## 4 User Specified Intercharac-
racter to Trigger Delay #
ter Delay
Cha DLY_XX## 4
Interfunction Delay DLYFNC## 4
Intermessage Delay DLYMSG## 4
Data Formatter Selections
*Default Data Format (None) DFMDF3 5
Enter Data Format DFMBK3## 5
Clear One Data Format DFMCL3 5
Data Format Editor
Clear All Data Formats DFMCA3 5
Off DFM_EN0 5
*On, but Not Required DFM_EN1 5
Data Formatter
equired
On, R DFM_EN2 5
1 VSAF_1 5
2 VSAF_2 5
Alternate Data Formats
3 VSAF_3 5
Symbologies
All Symbologies Off ALLENA0 6
All Symbologies
ymbologies On
All S ALLENA1 6
Codabar
Default All Codabar
Settings
CBRDFT 6
Off CBRENA0 6
Codabar
*On CBRENA1 6
*Don’t Transmit CBRSSX0 6
Codabar Start/Stop Char.
Transmit CBRSSX1 6
To Next Page
Loading...
