Chapter 10: Serial Programming Commands 10-13
Selection
Setting
* Indicates default
Serial
Command
# Indicates a
numeric entry
Chapter
*No Check Char. CBRCK20 6
Codabar Check Char. But Don’t Transmit CBRCK21 6 Validate,
date, and Transmit Vali CBRCK22 6
*Off CBRCCT0 6
Codabar Concatenation On CBRCCT1 6
ire Requ CBRCCT2 6
Minimum (2 - 60) *4 CBRMIN## 6
Codabar Message Length
Maximum (2 - 60) *60 CBRMAX## 6
Code 39
Default All Code 39
C39DFT 6
Settings
Off C39ENA0 6
Code 39
*On C39ENA1 6
*Don’t Transmit C39SSX0 6
Code 39 Start/Stop Char.
Transmit C39SSX1 6
k Char. C39CK20 6 *No Chec
Code 39 Check Char.
ate, But Don’t
smit
Valid
Tran
C39CK21 6
Validate,
and Transmit
C39CK22 6
Minimum (0 - 48) *0 C39MIN## 6
Code 39 Message Length
Maximum (0 - 48) *48 C39MAX## 6
*Off C39APP0 6
Code 39 Append
On C39APP1 6
Code 32 Pharmaceutical *Off C39B320 6
(PARAF) On C39B321 6
*Off C39ASC0 6
Code 39 Full ASCII
On C39ASC1 6
Interleaved 2 of 5
Default All Interleaved
I25DFT 6
2 of 5 Settings
Off I25ENA0 6
Interleaved 2 of 5
*On I25ENA1 6
Check Char. *No I25CK20 6
Interleaved 2 of 5 Check
Digit
date, But Don’t
smit
Vali
Tran
I25CK21 6
Validate, and Transmit I25CK22 6
To Next Page
Loading...
