104
MULTILINE APPEARANCE
To Originate a Call
STEP 1: Press the MULTILINE APPEARANCE fea-
ture key.
STEP 2: Lift handset or press key. Dial the
Central Office access code (i.e.9 (US), 0
(Aust)).
STEP 3: Dial the desired number.
To Answer a Call
STEP 1: Press the MULTILINE APPEARANCE fea-
ture key (ringing and flashing LED alert user
to incoming call).
STEP 2: Lift handset or press key.
STEP 3: Speak with incoming party.
TO HOLD A CALL
STEP 1: Press key. Held line wink flashes.
To Retrieve
STEP 1: Lift handset or press key.
STEP 2: Press held line. Use handset to converse.
If unanswered
STEP 1: After preprogrammed time, Automatic Recall
is initiated.
STEP 2: Visual and audible signal (rapid flash and ring
burst) is sent to station that placed call on
hold.
Note: Hold shows as a flashing green LED on your
phone. The same line on other phones shows as a
flashing red LED. Recall shows as a flashing
green LED on your phone and flashing red LED on
other phones with the same line.
Note:
If held line appears on other DT Series stations,
the associated LED flashes red slowly.
Note:
Any station with this line appearance can retrieve
the call.
To Next Page
Loading...
Need help?
General