121
SECURITY MODE
DT730 Series has the Security key which prevents
information leakage from terminal. While the terminal is
locked, Security Lamp lights up.
• TO LOCK THE TELEPHONE
Before placing DT700 Series in Security mode, you can
set a password. For details on the password setting,
see TO CHANGE PASSWORD in chapter 3 Terminal
Setup.
STEP 1: Press Security key on DT730 Series. The
following message is displayed on LCD.
STEP 2: Press or OK soft key to place DT700 Se-
ries in Security mode.
Note:
When the system administrator invalidates
the security mode, this function cannot be
used. For details of the security mode, con-
tact the system administrator.
Note:
While the telephone is locked, key
becomes disabled. Also, any features pro-
vided by the telephony server, such as call
origination or call answering, cannot be per-
formed.(The Incoming call cannot be picked
up though "Ringing" or "Voice call" are pos-
sible.)It is necessary to release the security
mode to respond.
Note:
To make a call of VOICE CALL is available
toward a called party in the Security mode.
When a called party activates the Security
mode with leaving its MIC to ON, the called
party can converse with a calling party
though terminal operation is restricted.
Note:
Even when the telephone is reset for any
reason (such as power-off, etc.) while the
telephone is placed in security mode, the
lock is not released.
To Next Page
Loading...
Need help?
General