MWSET (Message Waiting - Set)
Allows a station to set a Message Waiting indication or
lamp.
HOLD (Call Hold)
Permits a station user to hold a call in progress and to
return to the previously held call.
MWOFF (Message Waiting - Cancel)
Allows a station to cancel a Message Waiting indication
or lamp.
PICK (Call Pickup - Group)
Permits a station user to answer any calls directed to
other lines in the user's preset Call Pickup Group.
CONF (Three-way Calling)
Enables a station user to establish a three-way
conference by connecting an additional party to an
already existing conversation.
VOICE (Voice Call)
Enables you to make a call to the called party's built-in
speaker. If the called party's MIC is on, the called party
can converse on hands-free.
S-SPD (Speed Calling - System)
Allows a station user to call certain frequently dialed
numbers using fewer digits (abbreviated call codes)
than would normally be required.
CAS (CAS-Switch Hook Flash)
Allows you to send a switchhook flash while on an
outside trunk.
UCDBO (UCD Busy Out)
Allows a station user to block UCD calls and to cancel
Busy Out.
FLASH (Flash)
Provides the station with a switchhook flash.
FDN (Call Forward - No Answer)
Permits a call to an unanswered station to be forwarded
to a predesignated station if the called station does not
answer within a predetermined period of time.
C-RPT (ISDN Malicious Call Trace)
Allows you to initiate a Call Trace on ISDN calls only.
G-SPD (Speed Calling - Group)
Allows a station user to share a set of common Speed
Calling numbers with other station users in the group.
P-RLS (Privacy Release)
Allows another station to depress a busy line key and
enter the conversation of a station already engaged in
communication.
DND (Do Not Disturb)
Allows a station user to deny access to the station line
for incoming calls.
MIC (Microphone On/Off)
Allows you to turn the microphone on and off for use
with the speakerphone.
PAGE (Button Page)
Allows you to toggle between pages when two numbers
are registered on One-Touch Speed Calling key.
HSET (Headset)
Allows you to go off- and on-hook when using the
headset.
To Next Page
Loading...
Need help?
General