CHAPTER 3 SYSTEM DATA PROGRAMMING
– 144 –
NWA-008855-001 Rev.1.0
avch3001.fm
DESCRIPTION DATA
Assign the access code of paging groups for
Group Call-Automatic Conference (6/10-Par-
ty).
NOTE: Even if an extension does not belong
to the conference group, the exten-
sion can page the conference group,
and can re-participate in the confer-
ence if there is an idle circuit on the
Conference Trunk.
•
(1)
(2)
Y=0-3 Tenant Group No.
X-XXXX: Access Code
A200: Simultaneous Paging Group 0
for 6/10 Party
A207: Simultaneous Paging Group 7
for 6/10 Party
A210: Re-participation Group 0
for 6/10 Party
A217: Re-participation Group 7
for 6/10 Party
Assign the Group Call-Automatic Conference
(6/10-Party) key of each paging group to the
D
term
, if required.
NOTE: Even if an extension does not belong
to the conference group, the exten-
sion can page the conference group,
and can re-participate in the confer-
ence if there is an idle circuit on the
Conference Trunk.
•
(1)
(2)
Y=00
X-XXXXXXXX: My Line No. + + Key
No.
F0B00: Simultaneous Paging Group 0
for 6/10 Party
F0B07: Simultaneous Paging Group 7
for 6/10 Party
F0B10: Re-participation Group 0
for 6/10 Party
F0B17: Re-participation Group 7
for 6/10 Party
Specify the duration of simultaneous paging. •
(1)
(2)
Y=0
95
01-99: 4-396 seconds
(4 second increments)
If no data is set, the default setting is 32-36 sec-
onds.
A
CM20
~
~
~
~
CM90
,
~
~
~
~
CM41
END
WCS FEATURE PROGRAMMING
To Next Page
Loading...
