NEC NEAX 2000 IPS - Page 234

Soft Phone Wireless Handset
ND-91638-007(E) Page 37
Issue 6
■ To dial before placing the PS off-hook
1. Place the D
term
SP30 off-hook.
2. Dial a desired station number 2000 from the D
term
SP30, or select from the address book button, call logs,
or member buttons.
3. Place the PS off-hook, after dialing all digits from the D
term
SP30.
4. The station answers to start conversation (3000 is displayed on the LCD of the station as a calling number).
Note 1: Only the D
term
SP30 can cancel dialing in step 2. (Operation from the PS is disabled.)
Note 2: Only the PS can cancel operation of step 3 and later or end conversation. (Operation from the D
term
SP30 is disabled.)
■ To originate a call using a trunk key/Sub Line key
1. Press a trunk key/Sub Line key registered in the D
term
SP30.
2. Place the PS off-hook (hear dial tone).
3. Dial a destination number from the PS.
Note 1: Place the PS off-hook within 10 seconds after pressing a trunk key/Sub Line key.
Note 2: When originating a call using a Sub Line key, the station number of the Sub Line is notified to the called
party.
To answer a call
■ To answer a call to D
term
SP30
1. A station dials D
term
SP30 station number 3000.
2. Both of the D
term
SP30 and PS ring.
3. The PS answers to start conversation.
Note: D
term
SP30 cannot answer the incoming call.
■ To answer a call to a trunk key/Sub Line key
1. Press the trunk key/Sub Line key where a call is terminated.
2. Place the PS off-hook to start conversation.
Note 1: Place the PS off-hook within 10 seconds after pressing a trunk key/Sub Line key.
Note 2: When terminating a call to My Line, a call terminated to the trunk key/Sub Line key cannot be an-
swered.
Note 3: In order to answer with a trunk key, the trunk termination method must be “Trunk Line Appearance”
or “TAS”.
To hold a call in progress
1. Conversation is in progress with a station or CO line/tie line.
2. Press the Hold button on the D
term
SP30.
3. Hear service set tone from the PS.
4. The PS is released.
Note 1: Exclusive Hold is disabled.
Note 2: In the case of hold on a trunk, the call is held on the trunk key when the trunk is registered in a function
key. The call is held on My Line key when the trunk is not registered in a function key.