CHAPTER 2 INSTALLATION
– 43 –
NWA-008855-001 Rev.1.0
avch2001.fm
(3) Connect the PWR CNT CA-E or PWR CNT CA-D, and POWER OUTPUT
CABLE (–48 V, E) to the PZ-PW122 card as shown below.
Cable Connection between PZ-PW121/PZ-PW122 and BWB
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
PWR CNT CA-E (FOR PIM0)
PWR CNT CA-D (FOR PIM1 TO PIM7)
PWR0B
PWR1
PZ-PW121 BWB (BACK WIRING BOARD)
PIM
PWR0C
PWR0A
POWER OUTPUT CABLE (+90 V, CR, E)
PZ-PW122
POWER OUTPUT CABLE (+5 V, -27 V, E)
POWER OUTPUT CABLE (-48 V, E)
CARD SLOT AREA
LTC CONNECTOR AREA
CN103
MOUNTING PW122 CARD
To Next Page
Loading...
