Options 3-7
3. When removing an expansion slot cover from the inside of the ISA/PCI-Bus
backboard, separate the inside expansion slot L-bracket from the expansion slot
cover by removing the screw shown in Figure Section 3-14.
Reattach the L-bracket to the expansion board being installed.
Figure Section 3-14 Removing the Inside Expansion Slot Bracket
4. Install the expansion board into the expansion slot connector. When installing a
full-size expansion board, make sure that the expansion board slides into the guide
rail at the front of the system unit.
NOTE: A full-size expansion board cannot be
installed into the backside expansion slots.
5. Reinstall the expansion slot screw to secure the expansion board.
6. Connect any expansion board cables.
7. Replace the top cover.
Screw
L-Bracket
Slot
Cover
To Next Page
Loading...
