APPENDIX C USB PORT
117
When an over current of USB Device is detected, and will appear alternately at intervals
of one second.
If an over current is detected, power supply to the USB Port is stopped. To restart power
supply, remove the USB Device and resetting the terminal according to the following
procedure.
Disconnect and reconnect the LAN cable when the terminal receives the power supply
from the PoE Hub.
After removing the LAN cable, disconnect and reconnect the AC adapter cable when the
AC adapter is used.
When the LAN cable is removed or connected, be careful not to confuse the cable from the
PC side and the LAN.
For details about the display, refer to STARTING UP TERMINAL (WHEN EXTERNAL APPLICATION
IS NOT REGISTERED).
TO TAKE THE USB PORT COVER OFF
The USB Port Cover can be removed.
1.
Open the USB Port Cover.
2.
Pick up the USB Port Cover and pull it while sliding it to the left.
To Next Page
Loading...
