FEATURE OPERATION
77
TIMED QUEUING
(OUTSIDE LINE ONLY)
When a user originates an outgoing trunk call
and the called party is busy or does not answer,
the caller can set the Timed Queuing. When this
feature is set, the trunk seizure is repeated and
the number is dialed again after a predetermined
time interval.
The feature key is set by system data
setting at initial installation. For details,
please contact the system
administrator.
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2.
Dial Outside Line access code.
3.
Dial desired number.
You will receive a busy tone or a ring no
answer from distant end.
4.
Press Call Back feature key.
Line key lamp flashes green. →
5.
Leave speaker on.
The desired number is automatically
redialed.
6.
Start conversation with called party.
Busy tone is sent to the calling party
when the call is made to the extension
that is in Timed Queue mode.
TO MAKE/ANSWER A
CALL DURING CALL IN
PROGRESS
This feature permits a user to hold a call in
progress by pressing the Call Hold feature key.
This line can then be used for originating another
call or answering another incoming call. After
finishing another call and replace the handset,
the original held call rings back.
It is required that the dedicated feature
key other than fixed feature key (Hold)
shall be set by system data setting at
initial installation. For details, please
contact the system administrator.
1.
While call in progress,
The Line key lamp lights green. →
2.
Press call hold feature key.
Call hold feature key lamp doesn't light. →
The called party will receive a hold tone.
3.
To make a call to another party or
answer the incoming call.
Replace the handset after finishing a call.
To Next Page
Loading...
