NEC Univerge SV9300 - To Backup or Restore the Setting Data of Terminal

TERMINAL SETUP
50
CHECK POINTS
ACTIONS
Check whether the
power to
FTP/TFTP/HTTPS
server and network
equipment is ON or not.
Turn on the power.
Check whether the LAN
cable is connected
securely.
Reconnect the cable
securely.
If the retry of downloading fails many
times, the terminal may be in failure.
For details, please contact the system
administrator.
Other than above conditions, if
"Download Failed!" or "Upload Failed!"
is displayed, please contact the system
administrator.
TO BACKUP OR
RESTORE THE SETTING
DATA OF TERMINAL
This section explains how to make a backup of
the setting data which has been entered in the
terminal to FTP/TFTP/HTTPS server. The data
in FTP/TFTP/HTTPS server can be also restored
to the terminal.
When downloading these files, the
terminal needs to be connected to the
network that has FTP, TFTP or HTTPS
server.
For details about FTP/TFTP/HTTPS
service, please contact the system
administrator.
HTTPS protocol is supported for
terminal firmware 5.1.0.0 or later.
For details of terminal firmware version,
please contact the system
administrator.
TO BACKUP THE SETTING
DATA OF TERMINAL
1. Press key to display the Menu
Screen.
2. Select “Setting”.
Highlight an item by using , and press
.
3. Select “ Data Backup/Restore”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
4. Select “ Protocol”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
5. Select a Protocol type of the server
which stores the Backup file.
Select one of the following operations.
 Highlight an item by using , and
press or Soft key (OK).