NEC Univerge SV9300 - FEATURE OPERATION

TERMINAL SETUP
58
20. Press Soft key (Exit).
The display goes back to the
[Backup/Restore] screen.
When the downloading process ends in
failure, “Download Failed!” is
displayed on the
LCD. Check to see the
following points and retry download.
CHECK POINTS
ACTIONS
Check whether the
download file is
placed in the folder of
the server or not.
Place the download file
in the specified folder of
the server.
Check if the file name
you entered is match
with that stored in
FTP/TFTP/HTTPS
server.
Enter the correct file
name which is stored in
FTP/TFTP/HTTPS
server.
Is a download file a
terminal data file of
the same model?
Terminal data of the
different model (for
example terminal data
of DT750) can
’t be
downloaded. Please
download terminal data
of the same model.
Check whether IP
address/address
(URI)of
FTP/TFTP/HTTPS
server is correct or
not.
Set the proper IP
address/address
(URI)of
FTP/TFTP/HTTPS
server.
Check whether the
power to
FTP/TFTP/HTTPS
server and network
equipment are ON or
not.
Turn on the power.
Check whether the
LAN cable is
connected securely.
Reconnect the cable
securely.
If the retry of downloading fails many
times, the terminal may be in failure.
For details, please contact the system
administrator.
Other than above conditions, if
"Download Failed!" or "Upload Failed!"
is displayed, please contact the system
administrator.
TO USE HEADSET
TO MAKE/ANSWER A CALL
WITH HEADSET
By using optional headset, it is possible to
originate or respond to call. During using a
headset, the onhook/offhook operation can be
made by Headset/Handset feature key.
The feature key is set by system data
setting at initial installation. For details,
please contact the system
administrator.
TO MAKE A CALL USING HEADSET
While placing the handset on the terminal, make
a call using the headset.
1. Press Headset/Handset feature key.
Headset/Handset feature key lamp lights
red. →
Line key lamp lights green. →
2. Dial a desired number.
3. Start conversation after called party
answered.
4. Press Headset/Handset feature key
once again, after finishing a call.
Headset/Handset feature key lamp goes
off. →
Line key lamp lights off. →