NEC Univerge SV9300 - Call Waiting; Executive Override

FEATURE OPERATION
79
It is possible to select the last digit of
the extension number from 0-9
arbitrarily.
CALL WAITING
This feature allows a terminal to camp itself on to
a busy terminal.
This feature is available only for the
terminal that is set by system data
setting at initial installation. For details,
please contact the system
administrator.
TO ACTIVATE CALL
WAITING
1. Receive a busy tone.
BUSY 201
11:00 AM SUN 1 JUN 2014
CB
CW
>>>>
2. Press Transfer key.
3. Press Soft key (CW).
You will receive a special ringback tone.
CW SET 201
11:00 AM SUN 1 JUN 2014
Recall
VOICE
CB
>>>>
TO ANSWER CALL WAITING
1. Call in progress.
210
11:00 AM SUN 1 JUN 2014
MIC
Mute
2. Call Waiting feature is set.
Answer key lamp flashes red. →
You will receive a Call Waiting tone (three
tone bursts).
CALL WAITING 201
11:00 AM SUN 1 JUN 2014
MIC
Mute
3. Press Answer key.
The original party is placed on hold and
connected to another party who initiates
Call Waiting feature.
4. Press Answer key again.
Return to the original party and another
party is placed on hold. (It is possible to
change the connection as many times.)
EXECUTIVE OVERRIDE
This feature allows selected users to override a
busy condition on a called terminal.
The feature key is set by system data
setting at initial installation. For details,
please contact the system
administrator.
The terminal “b” is talking with the
terminal “c”, and the terminal “a” is going
to override the connection.
(1) Call in progress.
(2) Override.