NEC Univerge SV9300 - CALL HISTORY

FEATURE OPERATION
87
TO INITIATE
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Press Dial Intercom feature key.
Dial Intercom feature key lamp lights
green. →
ICM 200
11:00 AM SUN 1 JUN 2014
Recall
PICK
>>>>
3. Dial desired intercom terminal
number ( - ).
4. Press .
Change to ring tone signal.
Tone burst is sent.
TO ANSWER
1. While hearing ringing tone,
Dial Intercom feature key lamp flashes
green. →
Tone burst or ring tone is heard.
ICM 201
11:00 AM SUN 1 JUN 2014
MIC
DIR
HIST.
>>>>
2. Press Dial Intercom feature key.
Dial Intercom feature key lamp lights
green. →
3. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
INTERNAL ZONE PAGING
WITH MEET-ME PAGE
This feature allows terminal users to page over
the built-in speakers of the terminals within the
assigned zone or all zones.
The feature access code/feature key is
set by system data setting at initial
installation. For details, please contact
the system administrator.
TO PAGE (TERMINAL A)
The terminal A pages the terminal B.
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2. Dial Internal Paging access code for
desired zone or all zones or press
Internal Paging feature key
assigned for desired zone or all
zones.
PAGING
11:00 AM SUN 1 JUN 2014
Recall
PICK
>>>>
3. Page the terminal B.
TO ANSWER (TERMINAL B)
1. Dial Meet-Me Answer access code.
They are immediately connected.
200
11:00 AM SUN 1 JUN 2014
MIC
Mute