TERMINAL SETUP
31
TERMINAL SETUP
ADJUSTING VOLUMES
TO ADJUST HANDSET
RECEIVER VOLUME
It is possible to adjust the volume level of
handset receiver during a call in progress using
handset.
Press (Up) or (Down) in the offhook
status or during a call using the handset.
After replacing the handset, the receiver
volume returns to the original level.
TO ADJUST SPEAKER
VOLUME
It is possible to adjust the volume level of
speaker during a call in progress using speaker.
Press (Up) or (Down) during
speakerphone operation or during a call using
the speaker.
TO ADJUST RINGER TONE
It is possible to adjust the volume level of ringer
tone during incoming call arrival.
Press (Up) or (Down) during ringing.
TO ADJUST LCD CONTRAST
It is possible to adjust the LCD contrast when the
terminal is in idle status.
Press (Up) or (Down) when the
terminal is not used or ringing, etc.
TO SET RINGING OF
HEADSET
Following explains how to enable/disable the
ringing of headset.
This feature is required both terminal
and system setting at initial installation.
For details, please contact the system
administrator.
1.
Press key to display the Menu
Screen.
2.
Select “Setting”.
Highlight an item by using , and press
.
3.
Select “ User Setting”.
Select one of the following operations.
Highlight an item by using , and
press , or Soft key (OK).
Press .
To Next Page
Loading...
