NEC Univerge SV9300 - To Set a Language; To Change Password

TERMINAL SETUP
42
2. Select “Setting”.
Highlight an item by using , and press
.
3. Select “ User Setting”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
4. Select “ Display”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
5. Select “ Font Size”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
6. Select “Font Size”.
Select one of the following operations.
 Highlight an item by using , and
press or Soft key (OK).
 Press or , and press or
Soft key (OK).
TO SET A LANGUAGE
The language is set by system data
setting at initial installation.
Therefore, it is not required to change
the language on the terminal from
default setting ( Automatic). For
details, please contact the system
administrator.
TO CHANGE PASSWORD
Following explains how to change an existing
password. The password is used for the
following occasions.
 To lock/unlock the terminal.
 To reset the terminal settings.
1. Press key to display the Menu
Screen.
2. Select “Setting”.
Highlight an item by using , and press
.