NEC Univerge SV9300 - Page 51

TERMINAL SETUP
43
3. Select “ User Setting”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
4. Select “ Change Password”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
5. Enter the old password.
After entering the old password, press
or Soft key (Set).
The initial password is
“
0000
”
. When
changing the password for the first time,
enter “0000” as the old password.
In order to ensure the security and
avoid the unauthorized use, please be
sure to change the password at the time
of initial use. The password shall be
difficult to guess from a third party. And
it shall be changed regularly to keep
security level.
6. Enter the new password.
After entering the new password, press
or Soft key (Set).
Up to 32 digits can be set as a
password.
7. Enter the new password again.
8. Press or Soft key (OK).
The password entry completes
successfully.
 When the password entry in failure, the
following error message is displayed. In
that case, press or Soft key (OK) and
retry the password entry.
When a password has been forgotten,
please contact the system
administrator.