NEC Univerge SV9300 - Call Forwarding - Destination; CID (Caller ID) Call Display

FEATURE OPERATION
83
TO CANCEL
1. While being set the Call Forwarding
- All Calls,
2. Press the Soft key (>>>>) repeatedly
until display shows “FDA” when
Soft key is used.
MARY SMITH [200]
11:00 AM SUN 1 JUN 2014
FDA
FDN
>>>>
3. Press Soft key (FDA) or Call
Forwarding - All Calls feature key.
[CF-All Calls]
Forward to : 201
11:00 AM SUN 1 JUN 2014
Recall
PICK
>>>>
4. Press .
[CF-All Calls]
CANCEL
11:00 AM SUN 1 JUN 2014
5. After 4 second, return back to the
idle screen automatically. (or Press
Speaker key)
Speaker key lamp goes off. →
Line key lamp goes off. →
CALL FORWARDING -
DESTINATION
This feature allows a station user to set Call
Forwarding - All Calls from another station within
the system.
The feature access code/feature key is
set by system data setting at initial
installation. For details, please contact
the system administrator.
TO SET CALL FORWARDING
- DESTINATION
1. Dial Call Forwarding - Destination
feature access code or press Call
Forwarding - Destination feature
key.
You will receive a special dial tone.
[CF-I'm here]
SET 201
11:00 AM SUN 1 JUN 2014
2. Dial station number to be forwarded
to this line.
Wait for service set tone.
TO CANCEL CALL
FORWARDING -
DESTINATION
1. Dial Call Forwarding - Destination
Cancel feature access code or press
Call Forwarding - Destination
Cancel feature key.
[CF-I'm here]
CANCEL 201
11:00 AM SUN 1 JUN 2014
2. Dial station number to cancel.
3. After 4 second, return back to the
idle screen automatically. (or Press
Speaker key)
Call Forwarding - Destination is cancelled.
CID (CALLER ID) CALL
DISPLAY
Without answering incoming calls or held calls
that terminate to the Line keys of a terminal, the
calling party’s information can be confirmed by
the indications on the LCD.