NEC Univerge SV9300 - Page 59

TERMINAL SETUP
51
 Press , or , and press
or Soft key (OK).
The display goes back to the
[Backup/Restore] screen.
6. According to the selection in
[Protocol] screen, proceed to the
following steps below.
 When “ FTP” is selected here, go to
7.
 When “ TFTP” is selected here, go
to 15.
 When “ HTTPS” is selected here, go
to 7
7. Select “ Account Settings”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
8. Select “ User ID”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
9. Enter a User ID with digit keys.
Please refer to INPUT CHARACTERS
for how to enter the character.
 Enter a User ID with digit keys, and
press or Soft key (OK).
The display goes back to the [Account
Settings] screen.
10. Select “ Password”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
11. Enter a password with digit keys.
Please refer to INPUT CHARACTERS
for how to enter the character.
 Enter a password with digit keys, and
press or Soft key (OK).
The display goes back to the [Account
Settings] screen.