NEC Univerge SV9300 - TO SET AUTO PATH SWITCH

APPENDIX D PAIRING WITH SMART DEVICE
125
SWITCH THE MODE OF TERMINAL
When the terminal is connected with smart device though Bluetooth, the terminal mode can be
switched by pressing the Path key. (Wired Telephone Mode/ Mobile Phone Mode)
The status of the terminal mode switched by the Path key lamp is as follows.
MODE
LAMP COLOR
LAMP INDICATION
(Flashing interval is
shown in seconds)
TERMINAL STAUS
Wired Telephone Mode
Orange
Lighting
Smart device is idle or
not be connected.
Flashing
(0.25 ON-0.25 OFF)
Smart device is playing
music.
Wired Telephone Mode
Orange
Flashing
(0.125 ON-0.125
OFF-0.125 ON-0.625
OFF)
Smart device is
receiving an incoming
call.
Flashing
(0.5 ON-0.5 OFF)
Smart device is
originating a call or
talking.
Flashing
(0.125 ON-0.125 OFF)
Talking with smart
device.
Mobile Phone Mode
Green
Lighting
Smart device is idle or
ringing by
communication server.
Flashing
(0.125 ON-0.125 OFF)
Smart device is talking
with the caller through
communication server.
SWITCH THE MODE OF TERMINAL (WIRED TELEPHONE MODE/ MOBILE PHONE MODE)
1. Press Path key when the smart device is idle or receiving an incoming call.
2. The mode is changed. (Wired Telephone mode or Mobile Phone mode)
TO SET SMART DEVICE TYPE BY PATH KEY
This section explains how to set the type of smart device to be connected to the terminal by using Path
key. The following smart device types can be set to the terminal.
 Type1: iPhone, iPad
 Type2: Other Smart Device
1. Long press Path key, when the terminal is idle.
2. After the smart device type is set, confirmation beep is heard as follows.
Type1
Once (iPhone, iPad)
Type2
Twice (Other Smart Device)