INTRODUCTION
12
(1) Tilt Legs
(2) Stopper
(ITZ-12DG, ITZ-24DG)
3.
Turn the terminal over (key side up).
CONNECTING LAN CABLE
Connect LAN cable to the terminal following steps.
ILPA-R UNIT is required when PoE Hub supports NEC Proprietary Protocol (The ILPA-R
UNIT converts IEEE802.3af to NEC Proprietary Protocol). When ILPA-R UNIT is used,
1000BASE-T is not available.
For details, please contact the system administrator.
1.
Plug the power cable into the AC adapter connector when power is supplied with
AC adapter. This step is not required when PoE hub is used.
2.
Press the cable into the grooved cutout gently.
(1) DC Cable Plug
(2) AC Adapter connector
(3) Groove
(4) Attached DC Cable
(5) Terminal
(ITZ-24D, ITZ-12D, ITZ-8LDG, ITZ-8LD)
To Next Page
Loading...
