NEC Univerge SV9300 - Page 47

TERMINAL SETUP
39
2. Select “Setting”.
Highlight an item by using , and press
.
3. Select “ User Setting”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
4. Select “ Display”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
5. Select “ Screen Saver”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
6. Select “ Screen Saver Mode”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .
7. Select whether to launch up the
Screen Saver.
Select one of the following operations.
 Highlight an item by using , and
press or Soft key (OK).
 Press or , and press or
Soft key (OK).
The display goes back to the [Screen
Saver] screen.
8. Select “ Wait Time”.
Select one of the following operations.
 Highlight an item by using , and
press , or Soft key (OK).
 Press .