4-12 Troubleshooting and Repair
DISASSEMBLY AND REASSEMBLY
This subsection contains step-by-step disassembly procedures for the system. Reassembly is
the reverse of disassembly. Each procedure is supported by a simplified disassembly illus-
tration to facilitate removal. The detailed exploded-view diagram and parts lists for the sys-
tem unit are shown later in this subsection.
Required tools include a Phillips-head screwdriver. For complete disassembly of the system
unit, follow the disassembly order listed in Table Section 4-5 to reassemble, follow the table
in reverse order.
Table Section 4-5 Versa P Series Disassembly Sequence
Sequence Part See Page
1
Primary Battery Pack (NiMH Battery) 4-13
2 Memory Card 4-14
3 Hard Disk Drive 4-15
4 LCD 4-17
5 Top Cover 4-19
6 Keyboard 4-19
7 LCD Indicator Panel 4-21
8 Diskette Drive 4-22
9 CMOS Battery 4-24
10 CPU Board 4-25
11 Bridge Battery 4-26
12 VersaTrack Assembly 4-27
13 System Board 4-28
When disassembling the system unit, follow these general rules.
n Turn off and disconnect all power and all options, including the AC adapter (if
connected) and primary battery pack (see the procedures that follow).
n Do not disassemble the system into parts that are smaller than those specified in
the procedure.
n Label all removed connectors. Note where the connector goes and in what posi-
tion it was installed.
To Next Page
Loading...
