Troubleshooting and Options for the Docking Station II 5-21
Diskette/Tape Drive Installation
Use the following steps to install a diskette or tape drive in the Docking Station II. First,
read “Docking Station II Options” earlier in this section for pre-installation guidelines.
1. Remove the blank panel covering the appropriate drive slot. Slide the diskette
drive into the drive slot.
Figure Section 5-25 Diskette Drive Installation
2. Locate the signal connector on the diskette drive. Connect the signal cable to the
diskette drive connector. Locate the power cable connector on the diskette drive.
Connect the power cable to the diskette drive power cable connector.
Figure Section 5-26 Diskette Drive Cable Connections
Power
Connector
Signal
Cable
To Next Page
Loading...
