Troubleshooting and Options for the Docking Station II 5-23
Hard Disk Drive Installation
Use the following steps to install a hard disk drive in the Docking Station II. First, read
“Docking Station II Options” earlier in this section for pre-installation guidelines.
1. Locate the drive guide in the Docking Station II. Pull the drive guide lever away
from the drive bracket. Slide the drive guide up and out of the Docking Station II.
Figure Section 5-28 Hard Disk Drive Guide
2. Align the four holes on the drive guide with the four holes on the hard disk drive.
Figure Section 5-29 Drive Guide Hole Locations
3. Attach the hard disk drive to the drive guide using four screws.
Lever
Hard Disk
Drive Guide'
Hard Disk
Drive Bracket
Screw Holes Screw Holes
Screw Holes
Screw Holes
To Next Page
Loading...
