Memory/Storage Card
The memory/storage card may be inserted into either PCMCIA slot. When installing a
memory/storage card in the Versa P series system, it will appear as a unique drive. De-
pending on the type of card and slot used the drive designations are listed in Table 1.
Table 1 PCMCIA Drive Designations
Drive Letter Location/Device
C: Internal hard disk drive partition 1
D: Internal hard disk drive partition 2
E:
Slot 0 IDE
F:
Slot 1 IDE
G:
Slot 0 High-speed memory
H:
Slot 1 High-speed memory
NOTE: PCMCIA modem connections vary.
Refer to the modem's user documentation for
specific setup procedures.
Fax/Modem Card
Fax/modem cards must be inserted before starting the application software. If the
fax/modem card is not inserted before starting the application software, it will not find the
card. The fax/modem card may be inserted into either PCMCIA slot. The default
fax/modem card COM port/interrupt setting is COM2/IRQ3.
Fax/Modem Card — Single Connection Installation
The fax/modem card option comes with a telephone jack adapter. Connect the fax/modem
card to a telephone outlet using the following steps.
NOTE: It is not necessary to power-off the
system each time a card is installed.
To Next Page
Loading...
