5-10 Troubleshooting and Options for the Docking Station II
5. Remove the four screws securing the interface board to the bracket. Remove the
interface board from the bracket.
Figure Section 5-11 Interface Board Removal
Backplane Board
Use the following steps to remove the backplane board.
1. Remove the following as previously described.
n CRT base (if installed)
n top cover
n interface board.
2. Disconnect the cables from the backplane board.
Figure Section 5-12 Backplane Board Cable(s) Removal
Screws
Power Supply
Cable
Hard Disk Controller
LED Cable
LED Interface
Cable
To Next Page
Loading...
