5-24 Troubleshooting and Options for the Docking Station II
4. Locate the hard disk drive signal cable. One end of the signal cable is attached to
the Docking Station II's interface board. Attach the other end, connector C (for
the first hard disk drive) or connector D (for the second hard disk drive) to the
signal connector on the hard disk drive.
5. Locate the power cable connector on the hard disk drive. Connect the power ca-
ble to the hard disk drive power cable connector.
Figure Section 5-30 Hard Disk Drive Cable Connections
External CRT Monitor Installation
Use the following steps to install an external CRT monitor in the Docking Station II. First,
read “Docking Station II Options” earlier in this section for pre-installation guidelines.
1. Align the holes on the CRT base with the pins on the Docking Station II. Lower
the CRT base onto the Docking Station II.
Figure Section 5-31 CRT Base Installation
To Next Page
Loading...
