Troubleshooting and Options for the Docking Station II 5-15
Power Supply
Table Section 5-3 lists the Docking Station II power supply requirements.
Table Section 5-3 Power Supply Requirements
Characteristic Specification
Input Voltage (nominal) 100 to 240-V, Autosensing/Autoswitching
Frequency 50/60 Hz
Output Voltage +5V (7.3 A maximum)
-5V (0.1 A maximum)
+12V (8.0 A maximum)
-12V (0.3 A maximum)
+12VCHG (2.5 A maximum)
+5V (0.3 A maximum)
Use the following steps to remove the power supply.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover
n interface board.
2. Remove the two screws on the Docking Station II's rear panel.
Figure Section 5-17 Power Supply Screws (Rear Panel)
Power Supply
Screws
To Next Page
Loading...
