Setup and Operation 2-11
Auto Setup Keys
Refer to Table Section 2-5 for a description of Auto Setup Key functions.
Table Section 2-5 Auto Setup Key Functions
Key Function
Tab Moves cursor to another field in the menu. For example, pressing
Tab moves the cursor up or down a list of current parameters.
Highlighted letter Selects menu bar option or parameter with the highlighted letter.
Alt + down arrow Opens window with a list of parameter settings.
Up or down arrow Moves cursor up or down a list of parameter settings.
Esc Exits window without changing parameter settings.
C Saves parameter changes and closes the window. This function
also opens the Auto Setup Comms menu on the main screen.
Enter Saves parameter changes and closes the parameter window.
AUTO SETUP PARAMETER OPTIONS
Refer to Table Section 2-6 for a complete list of the parameters selectable through Auto
Setup. Parameter descriptions follow the table. Menu selections for the Auto Setup are the
same except where noted.
Table Section 2-6 Auto Setup Parameter Options
Menu Default Setting
Comms
Serial Port 3F8h — 3FFh/IRQ4 (COM1)
Parallel Port 378 h — 37Fh/IRQ7 (LPT1)
Parallel Port Mode Enhanced
Drives
Diskette Drive A Internal 1.44 MB
Diskette Drive B Not Installed
Hard Disk Drive 1 BIOS defined
Hard Disk Drive 2 Not Installed
IDE Hard Disk Interface Internal Only
Diskette Boot Enable
PCMCIA Boot Disable
To Next Page
Loading...
