5-28 Troubleshooting and Options for the Docking Station II
Parallel Printer Installation
Use the following steps to install a parallel printer for use with the Docking Station II. First,
read “Docking Station II Options” earlier in this section for pre-installation guidelines.
1. Power off the Docking Station II.
2. Attach the printer cable to the back of the printer. Attach the 25-pin printer cable
connector to the Docking Station II's parallel port.
3. Lock the connector to the printer with the connector clips. Secure the cable to the
Docking Station II with the screws provided.
Figure Section 5-35 Parallel Printer Connection
4. Connect the power cable to the printer. Power on the printer.
5. Power on the Docking Station II.
To Next Page
Loading...
