NEC VERSA P - Hard Disk Drive Guide Removal

5-16 Troubleshooting and Options for the Docking Station II
3. Disconnect all power supply cable connectors, including the power supply cables
connected to the backplane board, interface board, and drives.
4. To open the plastic clip securing the power supply cables, push the notch on the
plastic clip upward. Remove the power cables.
Figure Section 5-18 Removing the Power Cables
5. Press the lever on the hard disk drive guide away from the power supply and lift it
out of the Docking Station II.
Figure Section 5-19 Hard Disk Drive Guide Removal
Plastic Clip
Power Supply
Cables
Lever
Hard Disk
Drive Guide'
Hard Disk
Drive Bracket