5-6 Troubleshooting and Options for the Docking Station II
Top Cover Mask Assembly
Use the following steps to remove the top cover mask assembly.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover.
2. Position the top cover over so that the open end faces you. Remove the five
screws securing the top cover mask assembly to the top cover.
Figure Section 5-5 Top Cover Mask Assembly Screws
Blank Panels
Use the following steps to remove the blank panels.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover.
2. To remove a blank panel, push the notch on the left side of the blank panel and
move it to the right (see Figure Section 5-6).
Remove the blank panel.
Power Switch Assembly
Use the following steps to remove the power switch assembly.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover.
Screw (one of five)
To Next Page
Loading...
