NEC VERSA P - Saving Battery Power; Battery Pack Replacement

Setup and Operation 2-29
3. Insert the new battery pack into the battery compartment. Push the battery pack
into the compartment until it locks into place.
Figure Section 2-7 Battery Pack Replacement
4. Exit Suspend mode.
Saving Battery Power
The system utilizes three power conserving states: Active, Local Stand-by and Suspend
mode. The system automatically switches between these modes to conserve battery power
and prolong battery life. To save additional power, use the following guidelines:
n put the system in Suspend mode when you need to leave the system for a short
time
n reduce the LCD's brightness using BACKLITE.EXE or the FN F5 hot key to
toggle the LCD backlight between standard or full
n use the automatic hard disk power-saving function, set the timeout to power
down the hard disk with Auto Setup
n turn off the system when not in use.
The system also integrates automatic power-saving features. Refer to Table Section 2-7 for
a complete description.
Battery