NEC VERSA P - LED Panel Board; LED Panel Board Screws

5-12 Troubleshooting and Options for the Docking Station II
LED Panel Board
Use the following steps to remove the LED panel board.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover.
2. To remove the LED panel board, disconnect the LED interface cable from con-
nector 2 on the backplane board.
3. At the front panel, remove the two medium-type screws securing the LED panel
board bracket to the chassis using a medium-tipped Phillips head screwdriver.
4. Disconnect the other end of the cable from connector 1 on the LED panel board.
5. Remove the two small-type screws securing the LED panel board to the bracket
using a small-tipped Phillips head screwdriver.
6. Detach the board from the LED panel bracket and remove the board.
Figure Section 5-14 LED Panel Board Screws
Small-Type
Screws
Medium-Type
Screws
LED Interface
Cable
CN2
CN1