3-22 Options
DOCKING STATION
The Docking Station II increases the system's expandability by providing:
n an internal hard disk drive slot for one thin-type and one half-height 3 1/2-inch
drive
n a device slot that accepts up to two thin-type or half-height storage devices and
one full-size storage device
n two expansion board slots for two full- or half-size AT-style expansion boards.
For complete Docking Station II setup instructions refer to the Versa Series Docking Sta-
tion II User's Guide. For complete Docking Station II disassembly/reassembly repair proce-
dures and part numbers, see Section 5 in this manual. Use the following steps to attach the
Docking Station II to your system.
CAUTION: Turn off power to the Versa P and
docking station before connecting the Versa to
the docking station. If power is on during con-
nection, damage can occur to either system.
1. Check that the Versa P system and docking station are turned off. Open the sys-
tem's right rear cover on the system’s rear panel.
Figure Section 3-1 Opening the Rear Cover
Right-Rear Cover
To Next Page
Loading...
