4-26 Troubleshooting and Repair
Bridge Battery
Use the following steps to remove the bridge battery (see Figure Section 4-17).
1. Turn off the system power. Remove the battery and/or AC adapter if connected.
2. Remove the following as previously described:
n LCD
n keyboard
n hard disk drive.
3. Disconnect the bridge battery connector (P11) from the system board.
4. Tip the hard disk housing and lift it out of the chassis.
5. The bridge battery is secured on the side of the hard disk housing with double-
sided tape. Peel bridge battery off of the hard disk housing.
Figure Section 4-17 Bridge Battery on Hard Disk Housing
P11
Bridge
Battery
To Next Page
Loading...
