4-28 Troubleshooting and Repair
5. Disconnect the VersaTrack cable from connector CN3 on the system board.
Figure Section 4-19 VersaTrack Cable Connector
6. Lift the VersaTrack assembly up and out of the system frame.
System Board
Use the following steps to remove the system board (see Figure Section 4-20).
1. Turn off system power. Remove the AC adapter if connected.
2. Remove the following as previously described:
n primary battery pack
n LCD
n top cover
n keyboard
n LCD indicator panel
n memory card (if installed)
n CPU board
n hard disk drive
n diskette drive.
VersaTrack Connector
To Next Page
Loading...
