2-20 Setup and Operation
9. After the download is completed, log off the BBS.
Using the Update Utility
Load the BIOS Update utility as follows.
CAUTION: Never load a BUU from another
system model. That system's BIOS will be lost.
1. Power off the system unit.
2. Insert the BIOS Update Utility diskette into drive A.
3. Check that switch 1 on the dip switch is set to the “off” position.
4. Power on the system unit. The unit boots and automatically loads the utility. A
message similar to the following appears:
FLASH ROM EQUIPPED
WARNING: The BIOS Update Procedure
is about to begin, press ENTER to continue.
To abort, remove the diskette and reset the unit.
5. Press Enter to continue. The utility checks the currently installed BIOS version
and the diskette's BIOS versions. If the BIOS can be updated, the Main Menu ap-
pears (see the following screen). If there is a problem, the appropriate message is
displayed.
NEC BIOS Update Utility
Main Menu
Information
Display BIOS Version
Customize BIOS
Install New BIOS
Restore Original BIOS
Exit
To Next Page
Loading...
