3-20 Options
EXTERNAL DISPLAY
Use the following steps to attach an external display.
1. Check that the system and display power are turned off.
2. Press the left rear cover latch and open the left rear cover of the system.
3. Attach the display cable connector to the CRT port on the system.
Figure Section 3-4 CRT Port Location
4. Connect one end of the power cable to the display, connect the other end to a
power outlet.
5. Power on the display. Turn on the system. Set the system parameters for an ex-
ternal CRT using the LCD/CRT toggle key (Fn F3).
NOTE: It is very important to power on the
display before turning on system power in order
for the system to recognize the display.
Screws
To Next Page
Loading...
