Troubleshooting and Options for the Docking Station II 5-13
Sound Board
Use the following steps to remove the sound board.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover
n LED panel board.
2. Remove the two screws securing the sound board to the chassis. Remove the
board.
Figure Section 5-15 Sound Board Connector and Screws
Drive Signal Cables
Use the following steps to remove the diskette drive and hard disk drive signal cables.
1. Remove the following as previously described:
n CRT base (if installed)
n top cover.
2. Locate the diskette drive signal cable and disconnect the end attached to the disk-
ette drive connector. Next, disconnect the end attached to the interface board.
3. Remove the diskette drive signal cable.
Screws
Audio
Interface
Board
To Next Page
Loading...
