NEC VERSA P - System Password

3-18 Options
3. Press the VersaBay module firmly into the diskette drive slot.
Figure Section 3-2 VersaBay PCMCIA Module Installation
4. To reconfigure the system, select the “File” in the Windows Program Manager.
5. Select Run, type sysedit in the command line, and press Enter.
6. Click in the CONFIG.SYS window and scroll down to the line:
DEVICEHIGH=C:\CARDSOFT\CS.EXE
7. Modify the following three lines:
DEVICEHIGH=C:\CARDSOFT\SSCIRRUS.EXE
DEVICEHIGH=C:\CARDSOFT\CS.EXE
DEVICEHIGH=C:\CARDSOFT\ATADRV.EXE
as follows:
DEVICEHIGH=C:\CARDSOFT\SSCIRRUS.EXE /SKT 4
DEVICEHIGH=C:\CARDSOFT\CS.EXE /HEAPSIZE 4 /POLL 1
DEVICEHIGH=C:\CARDSOFT\ATADRV.EXE /D:4
This tells the operating system to constantly look at all four PCMCIA slots to see
if a card is present.
8. Save and exit the file. Reboot the system for the changes to take effect.
VersaBay
PCMCIA Module