Netafim NMC PRO CLIMATE - Page 11

NMC-PRO
USER GUIDE
Doc. Name: NMC-PRO ׀ User Guide Ver 3.05.03 Revision: 2.2 Page: 11
Crop Management Technologies
# Parameter Explanation Unit/Range Default
Weather Station
9.
Weather
Station
Define controller operation as one of the
following:
• LOCAL: Works only in the current
location and is not dependent nor
serves as a main controller
• SLAVE: Receives weather station
data from the MASTER controller
defined in the network
• MASTER: Is the main controller
within the network. Sends
weather station data to the
connected slave controllers
Local
Slave
Master
Local
10.
Storm Limit
m/s
Define the wind speed (meters/second)
which will indicate a Storm event
0-50 15
11. Storm on delay
Define the duration of time to measure
above the Storm Limit value for the
controller to recognize it as a Storm
event. This is to prevent gusts of wind to
be considered as storm events
00:10
12. Storm off delay
Define the duration of time to measure
below the Storm Limit value for the
controller to no longer recognize it as a
Storm event
01:00
13. Frost Limit °C
Define the outside tempe
rature which
will indicate a Frost event
-10°
14. Frost on delay
Define the duration of time to measure
below the Frost Limit value for the
controller to recognize it as a Frost event.
This is to prevent momentary drops of
temperature to be considered as Frost
events
01:00
15. Frost off delay
Define the duration of time to measure
above the Frost Limit value for the
controller to no longer recognize it as a
Frost event
01:00
16.
Rain event
detect
Define the quantity of rain (millimeters)
per minute for the controller to recognize
a rain event.
Note
: This parameter is enabled only
when a rain collector sensor has been
installed.
30
17. Rain on delay
Define the duration of time to measure a
rain indication for the controller to
recognize it as a Rain event
01:00