Doc. Name: NMC-PRO ׀ User Guide Ver 3.05.03 Revision: 2.2 Page: 5
Crop Management Technologies
INTRODUCTION
NMC Pro Climate is a climate controller that enables the user to control climate conditions,
setting them to the required level inside the climate zone (see zone explanation).
NMC Pro Climate controls up to four climate zones in a single controller.
In each zone, there is the option of controlling various climate systems such as:
• Vents
• Shading & Energy Screens
• Heating
• Misting
• Fan & Pad
• Air Circulation
• CO2
• Crop Protection
• Lights
Strong relationships and priorities are defined between the different control systems to
achieve maximum efficiency. Different influences (humidity, radiation, and temperature)
can be set to achieve maximum accuracy.
NMC Pro Climate has powerful communication capabilities between remote terminal units
and other controllers in the network, reducing cable costs and avoiding duplications through
receiving information from other controllers.
To maintain the same simplicity and user friendliness, the user interface has been kept as
similar as possible to the NMC Pro Irrigation.
CLIMATE ZONES
Climate zones are independent climate areas (covered and closed) which are used as
references for the climate control. Usually climate zones represent one greenhouse but in
some cases one greenhouse can be divided into four climate zones.
The reference sensor/s of each specific zone is the attached measuring box/es (Temp &
Humidity).
• Define any or all nine climate control systems inside the climate zone/s.
• Define up to four climate zones within the NMC Pro Climate controller.
The entire viewing structure and navigation throughout the user interface is based on the
climate zone/s.
To Next Page
Loading...
Need help?
General
