Netafim NMC PRO CLIMATE - Page 15

NMC-PRO
USER GUIDE
Doc. Name: NMC-PRO ׀ User Guide Ver 3.05.03 Revision: 2.2 Page: 15
Crop Management Technologies
Rain Sensor
11. Quantity per pulse mm – the quantity of rain per tipping. A Rain Collection sensor
must be installed for this parameter to be valid.
12. Rain detector sensitivity – set the voltage for rain detection (0-15)
NOTE: Parameter refers to an installed Rain Detector used for automatic detection
of a start and end of a rain event (Normally Open, closed during rain)
13. Rain damping – percentage taken from older reading (remaining percentage taken
from the newer reading). A Rain Collection sensor must be installed for this
parameter to be valid.
Humidity
14. Humidity calibration factor – difference between sensor reading and actual
humidity.
15. Humidity damping – percentage taken from older reading (remaining percentage
taken from the newer reading)
7.10.6 Weather station
19/01/09 16:21
Temperature
9. Temp calibration factor
10. Temp damping %
Rain Sensor
11. Quantity per pulse mm
12. Rain detector sensitive V
13. Rain damping %
Humidity
14. Humidity calibr. factor
15. Humidity damping %
0
95
10
2
95
0.0
95