netAlly AirCheck G3 - Page 124

See General Settings > VNC to enable and
configure VNC connections.
To connect to AirCheck G3 using a VNC client:
1. Get the IP address of a connected port
(preferably a management port) by swiping
down from the Status Bar at the top of the
screen to view the notification panel.
2. Provide the Wi-Fi Test or Management
Port's IP address to your chosen VNC client
application.
3. Connect using your VNC client.
4. If needed, enter the password that is set in
the VNC settings.
Using Link-Live Remote
The Link-Live Remote feature uses end-to-end
encryption, allowing secure remote control of
your AirCheck G3.
On your AirCheck G3, go to General Settings >
Link-Live Remote to ensure the feature is
enabled.
NOTE: If a Password is enabled in the VNC
General Settings, you must also enter the
Software Management
124